Spent today getting the second float half ready for resin.  Started out by laying the main laminate in place

Then I trimmed the excess away and use it to create extra layers of laminate where specified

The peel-ply was then put in place

and the RDM placed on top – I had some large scraps that were cut off the roll when infusing bulkheads, so I used this up as well

and finally I started tacking the bagging material into place after running resin and vacuum channels

Ended up calling it a night here – my back was hurting and I just wanted to lay down.  Hopefully dad will forgive me for leaving a mess in the garage since I didn’t pick up after trimming cloth and peelply… oops… 🙂

Did not get around to cutting chainplates apart today.

Time spent: 4.5 hours