are better than one…

This leaves a little extra room in the workshop….

and after shaving off some of the dried epoxy and fiberglass, we were able to flip the MDF sheets over and have a clean working surface to start tracing out main hull bulkheads

I’m trying some “new” fasteners from the Raptor Nail folks (well, they were a new product when they came out and I bought them… been sitting for a while)

Hopefully this saves some of the time it normally takes to glue the sheets together (wait for them to dry), before infusing them.

Got two sections worth ready to infuse

Did the first one but have not taken any pictures of it yet.

Hope to spend most of the Thanksgiving holiday making bulkheads so we can get started on the main hull.

Time spent: 5 hours